MEGA-180°-Drill-Alu
The MEGA-180°-Drill-Alu has a 180° point angle and a special bevel to produce a flat bore base. Due to its four-bevel geometry and the resulting very good guidance in the bore, the MEGA-180°-Drill-Alu achieves optimum roundness and surfaces in the bores. In addition, polished chip flutes ensure optimum chip transport. The MEGA-180°-Drill-Alu is also suitable for drilling and piloting on inclined surfaces of up to 45°. Due to the flat tip, the radial forces are reduced compared to conventional 140° drill tips.
Selected facets:
- ECU-Drill-Steel Product Family
- 5xD Drilling depth xD
- 6.0 Shank diameter (d2)
- MEGA-180°-Drill-Alu family
-
Product Family
0 Products found
for your selected filters.
Sorry, we couldn't find any results for your search
Suggestions:
- You may have typed your keywords incorrectly - please check for misspellings.
- You may have been too specific - please broaden your search by using fewer keywords.
- Browse our products by selecting a category above.
Added to Your Shopping Cart